burkey » user profile

Ah! Thank you!

Can't seem to find the 6x pack of the Rust-oleum Flat Black for that price - is that a typo for that colour?

To save your research; No it's not Nespresso compatible. This one uses Lavazza A Modo Mio type pods.

This has already arrived - honestly, it's about as good as you'd expect a $20 projector (which is, it's not really that good). It's not USB…

Have been pleasantly surprised by this filament - printed the Prusa MK4 pieces in the PETG-CF on the Bambu and they came out amazing. My…

Just the ones supplied - they were sufficient!

While normally I'm much the same, I found using some monitor arms gave me back some of that space. I mean your results may vary, but…

It was pre-oild, but I sanded it back/rounded the edges, and re-finished it. Personally I liked a smoother round edge on desks, and I had…

The legs expanded to the point of 'allowing' for a 1.8m desk. So with a 2.2m top, there was some overhang, but the main centre of mass was…

Would definitely recommend going the frame only and then you can get a top from Bunnings (something like this…

Cheers! I found that part of the issue is that I didn't realise Bambu slicer uses quite a higher temp for the generic PETG-CF, too. I just…

Was surprised how well this filament printed for the price - and also have had no issues with the cardboard spools in the Bambu AMS. It…

The 'was' price is a bit BS, as this is $46.90 on Amazon as a standard price:…

Cheers - alright, giving it a shot, curious about the CF filaments too, so yolo

Was keen to try it, but the shipping price really kills it. $22 to Vic.

Recently they rang me for a promo deal, saying that they'd give me a discount if I was to place an order - and that they could just put the…

I've played this game through many wipes - but right now cheating and hacking is at its absolute worst that it has ever been. Be prepared…

Sold out for shipping to Australia

"Member since 1 hour ago" Ah, you're one of those people that accidentally stumbled across OzBargain, when you were actually looking for…

10GB card would be considered "old stock" now, as they have been superseded by the 12GB model of the 3080.

The FEP and the LCD are considered consumables (the LCD's will burn out over time - but that time is many 1000's of hours). This is why…

Older style mSLA printers didn't use a monochrome screen, and required longer exposure times (8-9 seconds). These were essentially…

Depends what you're printing. PETG doesn't like to be super glued or painted, where PLA is fine with it. Really I use PETG when printing…

Apart from a "That's kinda cool" factor - what is the actual advantage of this being clear? And why would it be worth the extra ~$100 that…

Just be aware that this seller isn't the official Anycubic ebay store - they are only posing as one. This seller 'Anycubic-Make' has 134…

Mainly it was about setting the expectation - if you're happy to troubleshoot and spend time getting it tweaked and tuned - it's not bad…

You 100% are getting what you pay for with this printer. It's nothing amazing, and will likely be the cause of much frustration. Would…

Do not order when it is set as 'Call Us'. They will take your money, won't supply you the card, then hit you up for an administration fee…

Safe? It has no enclosure! You'll want to always be wearing your safety goggles when in the same room as this. And I definitely wouldn't…

Recently purchased one of these - unboxed it, and within 5 minutes the mount holding the screen gave way, causing the screen to fall over.…