Yowiefied » user profile

^ This. Would greatly appreciate if someone could share a Google drive link to the tracks.

Decent price! I bought an A7Cii recently to replace my A7ii, incredibly capable camera. Fantastic photos so far and the form factor means I…

Decent deal, given how bad our dollar is right now - probably as good as it’ll get unless they do a 15% off deal at Boxing Day.

Thank you, needed one of these.

Do they still require payment in crypto for ecig stuff?

It's on the Makita website https://www.makita.com.au/promotions And it applies to this specific model (DLM464PT2).

They look great, what’s your opinion on them by the way?

Same with my sectional/tilt door. I started researching on reddit/r/garageporn and a number of people are now going with motors that attach…

No not really, you'll definitely want a longer / taller boom for that.

There's actually a channel that goes around all the joints right down to the screw to stop the USB cable getting frayed.

I've got the Rode PSA1+ from what I can tell, the PSA1+ vs the blue compass there are few differences some of the notable ones are : - Dual…

I noticed with all my prints on Sunlu Black PETG it's very stringy, even down to 220c. What helped was throwing a fresh roll into the Sunlu…

Mine arrived today too. First wera set I’ve owned, great quality - says made in Czechoslovakia.

I've had it for about 24 hours now, I've owned a few Eufy products and am extremely happy with this one (wide camera angle, motion sensor,…

Limited support for Google Assistant/Home (at the moment) - you'll get live feed on voice command but that's it. It was an issue where…

Good point, though I've hardwired mine and I'll probably build a 3D print enclosure with a proper locking mechanism. Usage wise, i'm very…

Agreed, I had a Jamma arcade and converted it to a MAME machine. It was fantastic, had the original SF marquee, coin slots, even the…

Damn that's an awesome price for Wera.

Agreed, currently hovering at around 930Mbps, Wifi-6 devices connected at around 500Mbps.. it's fantastic.

I've actually gone back to original firmware from Merlin. Same router RT-AX88U. Had massive DHCP issues, drop outs every 4 days or so -…

Pretty sure you can, i'm currently running it as an AI-Mesh node. My primary is a AX88U and the AX55 is a node.

As someone who bought an Apple Clear MagSafe case, don’t buy it. Check the reviews it’s all horrible, difficult to press buttons, way…

I’ve had a good run with Sunlu (about 5 rolls so far of Black/Grey/White PETG on a Prusa MK3S). No stringing, consistent prints. Only…

I’ve got two, they’re cheap and they work pretty well. I’ll usually only turn them on if I haven’t used that roll for a while, or…

Me neither, they appear to be exactly the same on my MK3S. Not bad I’ve gone through approximately 5 rolls now and I’m a fan.

Yep it’ll take about 5 minutes per 12 psi on my car tyres.

T300 is a good entry level base, I had one then upgraded to a TS-XW/TS-PC Racer. They’ll be bringing out a Direct Drive unit this year…

Anecdotal I know, but I’ve had three heymix chargers and over a period of a year they’ve all slowly died on me. I’ll be sticking with…

Agreed with others comments here, I’ve gone through around 5 different stud finders over the years. This is the last stud finder you’ll…

So theoretically a hub can support 127 devices, where you run into problems is voltage to each device. Hence why if you have more than 4…